shoes5y7p
Dołączył: 08 Kwi 2011
Posty: 66
Przeczytał: 0 tematów
Ostrzeżeń: 0/5
Skąd: England
|
 Wysłany: Wto 4:30, 19 Kwi 2011 Temat postu: NFL Jerseys Sale How Skateboard Decks Are Manufact |
 |
|
e the wood has been shipped to the manufacturer, the veneer strips are audited. Any pieces that are too imperfect to create a skateboard will be darted out or recycled. The strips of veneer are then sorted into different piles, one with the grain running according the width of the rectangle,[link widoczny dla zalogowanych], and the other with the grain going against it.
The strips of veneer are then sent into a apparatus that applies paste to the svelte sheets. This paste namely equitable a customary, water based wood paste. It bonds quite well behind creature removed from the reception, and ensures that your skateboard does not skin apart.
Once the glue is on the veneer,[link widoczny dla zalogowanych], the strips are stacked to build the beginnings of a skate deck. Most skateboard decks are 7 ply skateboard decks. This just method that 7 layers of veneer have been floored to create the deck.
Next, the strips of veneer are layered to give the maximum strength to the board, with the first piece being a layer of veneer where the grain runs vertically along the board, and the second strip being one where the grain runs horizontally.
Once the veneer is layered properly, it is prepared to be processed in the skateboard press. Depending on what variety of skateboard is being built, the wood will be processed in differ presses. An antique educate shape and a fashionable school shape have to be pressed in alter presses, because the concaves are very different.
The skateboard press turns the smooth pieces of veneer into something with a tiny bit more shape. After being pressed, the skateboard decks are left to cure for twenty 4 hours or even longer. If the decks were not left to remedy before beyond processing, they would most probable warp and be unskateable.
After drying, the decks are processed even extra. Many skateboard manufacturers shape a embark with a machine that uses a completed deck as a template for cutting the excess wood off of a skateboard deck.
After the skateboard has been shaped, the chasms are drilled as accompanying trucks. A machine similar to the machine above is secondhand to do this. By utilizing a unattached skate deck as a template, skateboard producers tin create lots of skateboard decks that are about alike in shape and size.
After shaping the deck,[link widoczny dla zalogowanych], the edges are sanded manually by a worker. Many skateboard contractors own a sanding drum that the workers use to sand down the sharp rail above the deck. This makes the deck look detergent, and also helps prevent injuries to skaters and other objects by removing the sharp brims of the deck. Sanding the edges also can reserve the skateboard from cracking whether it runs into a wall or someone similar.
The skateboard is not complete without a picture on the bottom. Skateboard manufacturers shade publish deck graphics onto a thin strip of plastic, and then convey the image to the deck with heat. The left over plastic is removed to reveal the graphic on the base of the board.
After the graphic has been applied, the skateboard deck is covered with a wrapping that helps maintain the board and also the image on the bottom. This lacquer also gives a pretty bright to the deck, and brings out the color of the wood. The skateboard is then boxed up and shipped to an of the numerous skate marts skater to buy and enjoy.
Post został pochwalony 0 razy
|
|
